Barfeeder Application

Application: Top Load Sport used between a barfeeder and a Lathe.

The Problem: We have a barfeeder that will feed bars longer than the spindle. Right now the bars have to be cut to spindle length which is adding a cut operation, increasing amount of remnants and slowing down production.

The Solution: The Top Load Sport can be made as short as 11″ long. Using the Short Sport setup, the support is made with a narrow base and can fit between the barfeeder and the Lathe. This will extend the spindle capacity so that now you can run a 6′ bar instead of a 4′ one.


    • Use longer bars
    • Fewer cuts
    • Reduced overall loading cycles
    • Less scrap
    • More parts